What it does
A brooch stand is an upright faced panel that a brooch pins into, so the piece is seen face-on at eye level rather than lying flat where it reads as a disc.
Leather on a brooch stand, specifically
A pin should not go through hide — it leaves a permanent hole and the hide will not close. Leather goes on the body, with a fabric panel where the pin actually goes.
Getting the proportion right
The panel has to be soft enough to take a pin and firm enough to hold one. That means a faced board rather than a hard surface, and it means the facing is the working part of the display rather than a covering.
How leather is applied to a display form
Hide is cut, skived at the edges and wrapped, and grain varies from panel to panel. On a set of risers we cut every piece from the same hide so the set matches, and we say so on the drawing.
Where it is used
Antique and estate counters, where brooches are a real category, and window work where a single important piece is being shown face-on.
Leather under case lighting
Hide reflects softly and unevenly, which is what makes it look expensive and what makes it hard to photograph. It also darkens where it is handled, so an open-counter display in hide develops a patina rather than staying new.
The mistake to avoid
Repeated pinning in the same place wears a hole that shows when the piece is lifted out. A replaceable faced panel solves it; a permanently covered one has to be replaced whole.
Why leather
Leather-covered display carries the grain and the slight colour variation of hide. On a counter it reads as furniture rather than as a prop, and it ages with the shop rather than staying new.
Keep out of direct window sun, which lightens hide unevenly. A conditioner once a year on a piece that stays on show.
What we need from you
| What we need | Why |
|---|---|
| Height and footprint | The panel has to be soft enough to take a pin and firm enough to hold one. |
| Leather colour | Matched to a Pantone reference or a swatch |
| Leather on this form | A pin should not go through hide — it leaves a permanent hole and the hide will not close. |
Frequently asked questions
Can brooch stands be made in our brand colour?
Yes — the leather is matched to a Pantone reference or a physical swatch, and confirmed on a sample.
What sizes do brooch stands come in?
They are made to your dimensions. The panel has to be soft enough to take a pin and firm enough to hold one. That means a faced board rather than a hard surface, and it means the facing is the working part of the display rather than a covering.
Is leather a good choice for a brooch stand?
A pin should not go through hide — it leaves a permanent hole and the hide will not close. Leather goes on the body, with a fabric panel where the pin actually goes.
What goes wrong most often with brooch stands?
Repeated pinning in the same place wears a hole that shows when the piece is lifted out. A replaceable faced panel solves it; a permanently covered one has to be replaced whole.
Can brooch stands be made to match our boxes?
Yes — the same leather and the same colour across boxes and display, ordered in one run.
Specify your brooch stands
Tell us your case or window height, what the brooch stands have to show, and your brand colour. We’ll send photos of our work and one clear, all-in quote.