What this construction is
A slip-lid box is two separate pieces: a base and a lid that slides down over it. There is no hinge and nothing to break, and the lid can be lifted straight off so the piece is seen with nothing behind it.
Microfibre suede on this construction, specifically
Suede is thinner and more consistent than velvet, so a slip-lid fit in it is more predictable across a run. It is the fabric we would choose for a slip-lid where the tolerance has to hold over thousands of boxes.
Getting the fit right
The fit between lid and base is the whole specification. Too tight and the customer struggles; too loose and the lid comes off in a bag. The tolerance is small and it changes with the thickness of the covering, which is why it is set on a physical sample rather than on a drawing.
The mistake to avoid
Wrapping a slip-lid in a thick material without adjusting the base is the standard error. The lid then will not go down, and the fix is a new die rather than an adjustment.
Where it is used
Posted goods, premium presentation and anywhere the box has to look the same from every side. It is also the construction that stacks best in storage.
Why microfibre suede
Microfibre suede is a woven synthetic with a short, dense nap. It has the hand of real suede without the shading and water-marking that real suede brings, and it does not shed onto a polished piece.
Putting your logo on microfibre suede
Suede takes a hot-stamped or blind-debossed logo cleanly, because the nap compresses and holds the impression. Fine serifs need a slightly heavier die than they would on board, or the nap springs back and softens the edge.
Cutting the interior in microfibre suede
Inserts are cut a fraction under size on each face; the pile closes the gap and grips the piece without a visible squeeze.
Brush with the nap, never against it. Marks from a fingernail lift with a soft brush. It does not craze or crack with age.
What we need from you
| What we need | Why |
|---|---|
| Piece dimensions | Sets the interior |
| Microfibre suede colour | Matched to a Pantone reference or a swatch |
| Logo artwork | Vector gives the cleanest die or screen |
| Microfibre suede on this construction | Suede is thinner and more consistent than velvet, so a slip-lid fit in it is more predictable across a run. |
Frequently asked questions
Is microfibre suede a good choice for a slip-lid box?
Suede is thinner and more consistent than velvet, so a slip-lid fit in it is more predictable across a run. It is the fabric we would choose for a slip-lid where the tolerance has to hold over thousands of boxes.
How does microfibre suede wear on this construction?
Brush with the nap, never against it. Marks from a fingernail lift with a soft brush. It does not craze or crack with age.
Can it be made in our colour?
Yes — the microfibre suede is matched to a Pantone reference or a physical swatch, and confirmed on a sample.
What logo methods suit microfibre suede?
Suede takes a hot-stamped or blind-debossed logo cleanly, because the nap compresses and holds the impression. Fine serifs need a slightly heavier die than they would on board, or the nap springs back and softens the edge.
Can I see it before ordering?
Yes. A physical pre-production sample is made to your specification and the bulk run is held to the sample you approve.
Make your slip-lid boxes
Tell us the piece, your brand and the quantity you have in mind. We’ll send photos of our work and one clear, all-in quote.