HomeThe CollectionSienna Suede › Ring Box
Series CN-201 · Made to Order

Sienna Suede Ring Box

A ring presented in the Sienna Suede series — microfibre suede, made to your dimensions, your colour and your logo. A warm tan reads as gold-adjacent without competing with the metal. It flatters yellow gold and rose gold, and it is one of the few neutrals that does not make a diamond look cold. Counters that sell a lot of 18k gold tend to land here.

Sienna Suede ring box by Chung Ngai

Burgundy signature ring box with contrast lining, made by Chung Ngai
Signature ring box — burgundy exterior, twin-pad slotted insert

What a ring boxe has to do

A ring box holds a single ring upright in a fitted slot so the stone faces the customer when the lid opens. Two covered pads sit side by side with a cut between them; the ring is pushed down into the cut and the foam closes on the shank under its own spring.

Why Sienna Suede

Tan sits closest to yellow and rose gold on the colour wheel, so the metal reads as continuous with the box rather than set against it. On white metal the effect reverses — platinum against tan looks colder than it does against a grey or navy lining.

Getting the interior right

The cut is set to the widest shank the box has to take. A slot cut for a 1.5 mm band will not seat a 4 mm signet, and a slot cut for the signet lets the band lie over. Give both extremes if the box covers a range.

Where it belongs

Counters weighted to 18k and 22k gold. It is also the neutral most often chosen by jewellers selling into the Gulf, where yellow gold dominates.

The mistake to avoid

The measurement most often left out is the height of the setting. A raised solitaire needs clearance under the lid, and without it the lid presses on the stone.

Worth knowing before you commit

A warm tan shows dust more than a mid grey does. On an open display that is restocked weekly it is not an issue; in a window that is dressed once a season, it is worth knowing.

Microfibre suede

Microfibre suede is a woven synthetic with a short, dense nap. It has the hand of real suede without the shading and water-marking that real suede brings, and it does not shed onto a polished piece.

What we need from you

What we needWhy
DimensionsThe widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width.
Exterior colourMatched to a Pantone reference or a physical swatch
Lining colourChosen against the metal and the stone
Logo artworkVector where possible, for the cleanest die or screen

Frequently asked questions

Can the Sienna Suede series be made in a different colour?

Yes. The colour shown is the standard for the series; exterior, lining and stitching are all specified per order. Send a Pantone reference or a swatch and we match to it, then confirm on a sample.

What logo methods suit microfibre suede?

Suede takes a hot-stamped or blind-debossed logo cleanly, because the nap compresses and holds the impression. Fine serifs need a slightly heavier die than they would on board, or the nap springs back and softens the edge.

What do you need to make a ring boxe?

The widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width.

Can I see it before ordering?

Yes. A physical pre-production sample is made to your specification and the bulk run is held to the sample you approve.

Make this in Sienna Suede

Tell us the ring, your brand and the quantity — we'll send photos of our work and one clear, all-in quote.