What a ring boxe has to do
A ring box holds a single ring upright in a fitted slot so the stone faces the customer when the lid opens. Two covered pads sit side by side with a cut between them; the ring is pushed down into the cut and the foam closes on the shank under its own spring.
Why Slate Blue
A C-cushion is curved rather than flat, so a bangle or a wide cuff sits down into the seat instead of resting on top of it. That is the difference between the lid closing and the lid pressing.
Getting the interior right
The cut is set to the widest shank the box has to take. A slot cut for a 1.5 mm band will not seat a 4 mm signet, and a slot cut for the signet lets the band lie over. Give both extremes if the box covers a range.
Where it belongs
Counters selling bangles, cuffs and wider bracelets.
The mistake to avoid
The measurement most often left out is the height of the setting. A raised solitaire needs clearance under the lid, and without it the lid presses on the stone.
Worth knowing before you commit
The cushion has to be cut to the inner diameter of the piece. Send the bangle measurement, or a photograph against a ruler, before the insert is made.
Microfibre suede
Microfibre suede is a woven synthetic with a short, dense nap. It has the hand of real suede without the shading and water-marking that real suede brings, and it does not shed onto a polished piece.
What we need from you
| What we need | Why |
|---|---|
| Dimensions | The widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width. |
| Exterior colour | Matched to a Pantone reference or a physical swatch |
| Lining colour | Chosen against the metal and the stone |
| Logo artwork | Vector where possible, for the cleanest die or screen |
Frequently asked questions
Can the Slate Blue series be made in a different colour?
Yes. The colour shown is the standard for the series; exterior, lining and stitching are all specified per order. Send a Pantone reference or a swatch and we match to it, then confirm on a sample.
What logo methods suit microfibre suede?
Suede takes a hot-stamped or blind-debossed logo cleanly, because the nap compresses and holds the impression. Fine serifs need a slightly heavier die than they would on board, or the nap springs back and softens the edge.
What do you need to make a ring boxe?
The widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width.
Can I see it before ordering?
Yes. A physical pre-production sample is made to your specification and the bulk run is held to the sample you approve.
Make this in Slate Blue
Tell us the ring, your brand and the quantity — we'll send photos of our work and one clear, all-in quote.