What a ring boxe has to do
A ring box holds a single ring upright in a fitted slot so the stone faces the customer when the lid opens. Two covered pads sit side by side with a cut between them; the ring is pushed down into the cut and the foam closes on the shank under its own spring.
Why Sage Velvet
Sage with cream is the soft green — it reads contemporary rather than traditional, and it works with the pale-wood, low-contrast interiors that have become common.
Getting the interior right
The cut is set to the widest shank the box has to take. A slot cut for a 1.5 mm band will not seat a 4 mm signet, and a slot cut for the signet lets the band lie over. Give both extremes if the box covers a range.
Where it belongs
Modern independents and pale, minimal fit-outs.
The mistake to avoid
The measurement most often left out is the height of the setting. A raised solitaire needs clearance under the lid, and without it the lid presses on the stone.
Worth knowing before you commit
Pale greens shift under warm shop lighting and can read yellow. Check the sample under your own lights, not under daylight.
Velvet
Velvet is a cut-pile fabric with a longer, softer nap than microfibre suede. It is the traditional jewellery lining and still the one most buyers associate with a gift.
What we need from you
| What we need | Why |
|---|---|
| Dimensions | The widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width. |
| Exterior colour | Matched to a Pantone reference or a physical swatch |
| Lining colour | Chosen against the metal and the stone |
| Logo artwork | Vector where possible, for the cleanest die or screen |
Frequently asked questions
Can the Sage Velvet series be made in a different colour?
Yes. The colour shown is the standard for the series; exterior, lining and stitching are all specified per order. Send a Pantone reference or a swatch and we match to it, then confirm on a sample.
What logo methods suit velvet?
Velvet does not hold a hot-stamp the way board or leatherette does. A metal plate, or a lid card, is the more reliable way to carry a logo on a velvet exterior.
What do you need to make a ring boxe?
The widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width.
Can I see it before ordering?
Yes. A physical pre-production sample is made to your specification and the bulk run is held to the sample you approve.
Make this in Sage Velvet
Tell us the ring, your brand and the quantity — we'll send photos of our work and one clear, all-in quote.