HomeThe CollectionBlush Suede › Ring Box
Series CN-305 · Made to Order

Blush Suede Ring Box

A ring presented in the Blush Suede series — microfibre suede, made to your dimensions, your colour and your logo. Dusty blush with a tonal interior is softer than Rose Suede — the colour is greyer and less overtly bridal, which widens where it can be used.

Blush Suede ring box by Chung Ngai

Burgundy signature ring box with contrast lining, made by Chung Ngai
Signature ring box — burgundy exterior, twin-pad slotted insert

What a ring boxe has to do

A ring box holds a single ring upright in a fitted slot so the stone faces the customer when the lid opens. Two covered pads sit side by side with a cut between them; the ring is pushed down into the cut and the foam closes on the shank under its own spring.

Why Blush Suede

A greyer, dustier blush than Rose Suede — the tonal interior keeps the whole box in one register, which suits delicate pieces that a contrasting lining would overpower.

Getting the interior right

The cut is set to the widest shank the box has to take. A slot cut for a 1.5 mm band will not seat a 4 mm signet, and a slot cut for the signet lets the band lie over. Give both extremes if the box covers a range.

Where it belongs

Everyday fine jewellery and gifting, where bridal-pink would be too specific.

The mistake to avoid

The measurement most often left out is the height of the setting. A raised solitaire needs clearance under the lid, and without it the lid presses on the stone.

Worth knowing before you commit

Tonal interiors give less contrast, so a very fine chain can disappear. For thin pieces, ask for a slightly deeper lining tone.

Microfibre suede

Microfibre suede is a woven synthetic with a short, dense nap. It has the hand of real suede without the shading and water-marking that real suede brings, and it does not shed onto a polished piece.

What we need from you

What we needWhy
DimensionsThe widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width.
Exterior colourMatched to a Pantone reference or a physical swatch
Lining colourChosen against the metal and the stone
Logo artworkVector where possible, for the cleanest die or screen

Frequently asked questions

Can the Blush Suede series be made in a different colour?

Yes. The colour shown is the standard for the series; exterior, lining and stitching are all specified per order. Send a Pantone reference or a swatch and we match to it, then confirm on a sample.

What logo methods suit microfibre suede?

Suede takes a hot-stamped or blind-debossed logo cleanly, because the nap compresses and holds the impression. Fine serifs need a slightly heavier die than they would on board, or the nap springs back and softens the edge.

What do you need to make a ring boxe?

The widest shank width, the height from the base of the shank to the top of the setting, and whether the box has to take a range or a single width.

Can I see it before ordering?

Yes. A physical pre-production sample is made to your specification and the bulk run is held to the sample you approve.

Make this in Blush Suede

Tell us the ring, your brand and the quantity — we'll send photos of our work and one clear, all-in quote.